WEEE Directive Information X-Stream

WEEE Directive Information

Recycling Passport For the X-Stream* Laparoscopic Irrigation Controller Used with the disposable codes for X-Stream Laparoscopic Irrigation tubing sets

This product is subject to RGA Returns for Reusable Products QA-19.8. If choosing not to return the unit according to the instructions for use the following information is offered in order to establish an economic recycling strategy.

 

Technical Drawings: 

X-Stream controller.pdf

 


Identification of Product










 

 


5551009, 5551000 9551009, 9551000

The controller is reusable and subject to a repair and service procedure QA-19.8

X-stream* Laparoscopic Irrigation Controller Product must be used with a disposable tubing set which will be a biohazard after use

The International controller 5551009 consist of the 5551000 with the addition of a power cord set and the multilingual labeling.

 


Accessories include


 

 
5552000, 5552001, 5552002, 5552003

All of these products are disposable pump tubing sets according to hospital procedures for biohazard waste after use.


Hazardous components


none


Unit Housing


Polycarbonate front and back held together with four screws.

 

Power Supply


65W Medical grade open PCB switching power Supply Condor GLM 65-24 or equivalent

 
Power cord USA

 

 

International cords

 

 

  1. Cord, power, with Ground Level (87-1630)
  2. A 2.5 meter long cord set comprising a molded “hot condition lead” style socket and B1363/A mains plug. Cord set assembly shall meet the requirements of EN60-320.
  3. IEC/Schuko Non-UK mains leads cord set for International X-Stream Laparoscopic Irrigation System Controller-REM


Power entry module


IEC EMI/EMC inlet filter

 
Motor

 
Is located in the disposable cartridge


Circuit Board 


Power inductor .9 amps 150 OUH


Unit structures

 


Front Assembly
Contains switch controls

Insert assembly
Contains electrical contact for disposable cartridge with motor

Cradle Assembly
Contains circuit board with phototransitor and infrared emitting diode

Rear Assembly
Contains power supply, power entry and IV pole support

 
Polymer materials

 
Silicone Rubber, Acrylic Adhesive, Nylon , Polyethylene, Polyester, Phenolic, Loctite®, Delrin®, and Neoprene.


Metals


Stainless Steel, nickel/copper, aluminum, brass 

 


Information about materials or components which can disturb recycling processes (access, location, removal) 


None known 

Component listing  

See numbered drawing with parts list that follows
 


*X-Stream     is a trademark/registered trademark of C. R. Bard or an affiliate.

Loctite is a trademark/registered trademark of Henkel Corporation

Delrin is a trademark/registered trademark of E.I. DUPONT DE Nemours

 

ordering information